The manufacturing process for wheel nuts depends on the type of material used to make them. The following is a general overview of the process:
The specifications for hexagon flange nuts with metallic or non-metallic flanges are outlined in DIN 6923. International use and recognition of this German standard are common.
There are two widely accepted worldwide standards for hex nuts: ISO 4032 and DIN 934. There are various distinctions between the two standards, despite the fact that they serve the same overall objective.
A type of fastener called a completed hex nut is frequently used to hold bolts, screws, or studs in place. The middle of the six-sided object contains a threaded hole that matches the thread of the bolt or screw it is used with. The nut's finish is normally either plain or covered in a layer of zinc, which offers defense against rust and corrosion.
The specification for hexagon nuts with metric thread diameters is DIN 934. The standard includes nuts with a size range of M1.6 to M64. Since the grade is normally defined separately for the bolt or stud being used with the nut, DIN 934 does not specify a specific grade for the material of the nut. Hexagon nut grades are primarily distinguished by markings on the nut, with Grade 8, Grade 5, and Grade 2 being the most frequently used grades.
Naruts are the parts that are screwed with bolts or screws to play a tightening effect. One component that all manufacturing machinery must be used is divided into carbon steel, stainless steel, non -ferrous metals (such as copper), etc. Several types.
